Swamp Cooler Repair in Burleson That Gets the Breeze Back
Evaporative coolers are simple machines, but a dried-out pad, a stuck float or a tired pump can stop them cold. HVAC Repair Burleson provides swamp cooler repair and service for roof-mounted, window and portable units, with Texas-licensed technicians and a clear explanation before any work starts.
- Pads, pumps, belts & motors
- Roof, window & portable units
- Honest repair-or-replace advice
Signs Your Swamp Cooler Needs Service
Most evaporative cooler problems come down to water, airflow or wear. If you notice any of these, our swamp cooler service can usually fix it in one visit.
Air Feels Warm
Dry pads or poor water flow mean little evaporation and barely cool air.
No Water on the Pads
A failed pump, clogged distributor line or stuck float valve starves the pads.
Leaks or Overflow
Worn float valves, cracked pans or loose fittings send water where it should not go.
Weak Airflow
A slipping belt, worn bearings or failing motor slows the blower.
Squeals & Rattles
Dry bearings, loose pulleys or a frayed belt make noise before they fail.
Musty or Fishy Smell
Mineral-crusted or moldy pads and stagnant water need cleaning or replacement.
Complete Evaporative Cooler Repair & Service
Our technicians work on downdraft and side-draft roof units, window coolers and portable models. Every visit starts with a full check of the water system, blower and electrical parts, so we fix the cause instead of guessing.
- Cooler pad replacement (aspen and rigid media)
- Water pump repair and replacement
- Float valve and supply line repair
- Blower motor, belt and pulley service
- Distribution lines and water trough cleaning
- Bleed-off kit installation to limit mineral scale
- Thermostat and switch troubleshooting
- Rust repair and pan sealing
Is a Swamp Cooler Right for Burleson Weather?
Evaporative coolers work by adding moisture to dry air, so they shine on hot, low-humidity days and lose power when the air is already muggy. In Burleson they perform best in shops, garages, barns and patios, and on the drier days of early summer. When humidity climbs above about 50 to 60 percent, even a perfectly tuned unit will struggle to cool a sealed living space.
We will always tell you straight whether repairing your cooler makes sense or whether an AC replacement would keep you more comfortable for the money.
Swamp Cooler
- Low running cost and simple parts
- Brings in fresh outside air
- Best for dry heat, shops and patios
- Needs a water line and regular pad changes
Central AC
- Cools well even in humid weather
- Removes moisture from indoor air
- Best for whole-home comfort
- Higher initial cost, sealed system
Spring Start-Up & Fall Shutdown
A quick visit at each end of the season keeps your cooler efficient, clean and leak-free, and prevents freeze damage to water lines in winter. Learn more about our swamp cooler winterization service.
Spring Start-Up
- Install fresh cooler pads
- Clean the pan and flush the water lines
- Test pump, float and water distribution
- Check belt tension and lubricate bearings
- Verify motor amps and electrical connections
Fall Shutdown
- Shut off and drain the water supply line
- Empty and clean the water pan
- Disconnect the pump and blower power
- Install a cover to block cold drafts
- Note any rust or wear for spring repairs
Our Swamp Cooler Repair Process
Call or Book
Tell us the cooler type and what it is doing. We schedule the first open slot.
Full Check
We test water flow, pump, float, pads, blower, belt and wiring.
Honest Advice
You get a clear repair or replacement recommendation before any work.
Repair & Test
We fix it, run the cooler and confirm a strong, cool airflow.
Local rules: routine swamp cooler repairs do not need a City of Burleson permit. Installing a new cooler with a new water line or electrical circuit may require a permit, and the water supply must have proper backflow protection under the plumbing code so cooler water can never flow back into your drinking water. We handle that work to code and tell you in advance when a permit applies.
Swamp Cooler Questions
Straight answers about evaporative cooler service in Burleson. Need more help? Talk to a technician.
It depends on the part. Pads, floats and belts are inexpensive, while a new blower motor costs more. We diagnose first and explain the repair before any work.
Aspen pads usually need replacing every season. Rigid media pads can last several years with good bleed-off and cleaning. Our hard North Texas water speeds up mineral buildup, so yearly inspection is smart.
Stagnant water, algae or mold on old pads cause musty or fishy odors. Cleaning the pan, flushing the lines and replacing the pads usually solves it.
If the cabinet is solid and the repair is a pad, pump or belt, yes. If the pan is rusted through or the motor and housing are failing, we will compare the cost with a new cooler or an air conditioner.
Yes. We replace worn-out units and install new coolers, including the water line, backflow protection and electrical connection, with any required permit.
Yes. Before the first hard freeze we drain, clean, disconnect and cover evaporative coolers so the water lines and pump are protected. See our swamp cooler winterization service.
Get Your Swamp Cooler Running Again
Tell us about your cooler and we will call you back to set a time. Prefer to talk? Call (817) 839-0304. Also see our AC repair and AC maintenance services.
- Texas-licensed technicians
- Clear answers before work
- Repairs for every cooler type